Follow through..

What's up everyone?

So iv been building a new machine and got it running nice, but when connecting it to my hurricane it says the FT is 39..

The machine itself looks, feels and sounds good but still to be tested in skin.
Set as a soft shader, long stroke 3-4mm airgap, 10 layer coils, 47uf cap, runs at around 6-7 volts, 125cps and a duty cycle of 46%

Does FT really matter?
Any tips to reduce it?

Thanks on advance

That's really high, maybe it's your power supply. I still have y hurricane I'm gonna pull it out later after work and run some of my coils it to see ft/stl. I'm sure most of my magazines were under 10, I think one or two were more.

So my FT is 1% less than my duty cycle and its the same for all my machines lol.

Must be my supply..

Just hooked up a rotary, it has a duty cycle of 26% lol...

The supply works just can't rely on the numbers.

When I use rotaries my power supply says 100%

The highest stl on any of my machines is 4% of my liners are 0% another is at 4% and most of my shaders are 4 including my 2 color packers